Quick Answer: What Speed Should I Run My Router?

Do I need a variable speed router?

You might need variable speed in the table if you plan to use any big router bits: lock miter bits, panel raising bits, or big roundovers.

These should be run at slower speed.

If you’re going to make small-ish projects like boxes, consider a trim router..

How do I keep wood from burning through my router?

Make router burn marks disappear1 Too much speed. Fast-turning large bits generate wood-searing heat. … 2 Heavy passes. Take off no more than 1⁄ 8 ” of material with each pass—less on the final one.3 Slo-o-o-ow pace. To avoid heat build-up, feed stock as quickly as possible without leaving chatter marks.4 Dull bits.

What should I look for when buying a router?

How to choose a wireless router: 10 things to consider!Your router should have a multi-core processor and at least 128MB of RAM. … The router that you choose should be dual-band or more. … Router naming conventions should NOT be taken into account when making your buying decision. … Verify online the real-life speed of the router that you buy.More items…•

Is a wood router worth it?

A wood router is a very effective way to for enhancing the design of any project. You can use a router on wood, fiberglass, and plastic. You can even use a router to engrave, shape, groove, or to make door panels. The cutting action on a router comes from the sides of it rather than the tip.

How powerful of a wood router do I need?

Horsepower determines how powerful your router will be, and collets determine the size of bit it can take. Most routers deliver horsepower in a 1 ½ to 3 ½ range, with a range of 3 to 15 amps. Maximum HP should only be attained and used for a short period of time.

Why is my router burning the wood?

Chris Marshall: If your router doesn’t haven’t have variable-speed control, it could be spinning the bits too quickly … and fast cutters held against wood equals heat buildup and burning. Try increasing your feed rate. The faster the cutter gets through the wood, the less heat it builds up.

How deep should router bit be?

If you’re cutting a groove, set up the cut, and then adjust the bit so it’s cutting somewhere around ¼-inch deep. Make the cut, lower the bit, and repeat until you’ve cut a groove the desired depth.

Do you push or pull a router?

When looking straight down at the top of a router, the bit rotates in a clockwise direction. That means you should move the router from left to right, but—and this is important—that’s only true when the router is positioned in the middle between you and the workpiece.

What is the best router for a beginner?

The Best Wood Router for BeginnerBOSCH MRC23EVSK 2.3 HP Combination Plunge & Fixed-Base Variable-Speed Router.The DEWALT DWP611PK 1.25HP.Makita RT0701CX7.BOSCH Colt Palm Grip.PORTER-CABLE 690LR 11-Amp Fixed-Base Router.

Do you use a router left to right?

When you’re holding the router in hand with the bit facing downward, it will spin in a clockwise direction. To feed against the bit’s rotation then, you’ll move the router from right to left when feeding the router along the outside edges of a work- piece.

What is the advantage of a plunge router?

Plunge routers allow you to read and fine-tune the depth right on the router’s face. One advantage a plunge router has over a fixed-base model is bit protection. A plunge router automatically surrounds and protects your expensive bits when it’s not in use.

Why do router bits break?

Quite often the reason the router bits discolor is that they are run too slowly. Router bits are designed to be run at a certain speed. If you run them too slowly, they bog down in the material, friction builds up and they can get to hot.